While the original model was primarily focused on local wireless communication and short-range device control, the Flipper One shifts its focus to networking. The device is equipped with two Ethernet ports and support for the modern Wi-Fi 6E standard. The icing on the cake is the built-in M.2 slot, which allows users to optionally install a 5G mobile modem. External modules with high data transfer speeds can be directly connected via PCI Express, USB 3.0 and SATA buses, which means that the device can be transformed into a portable 5G router, a secure VPN point or a powerful bridge between wired and wireless networks in an instant.<\/p>\n\n\n\n
Under the hood is hardware that goes beyond the scope of conventional microcontrollers. In addition to a power-efficient chip for basic tasks, the Flipper One is powered by a Rockchip RK3576 processor with ARM architecture, which combines four powerful Cortex-A72 cores and four power-efficient Cortex-A53 cores, and is accompanied by 8 GB of fast LPDDR5x RAM. Such raw power is easily enough to run a full-fledged Linux operating system. Via the built-in HDMI interface, you can connect the device to more processor-intensive designs with 4K resolution at a refresh rate of up to 120 Hz, turning the hacking gadget into a functional desktop computer.<\/p>\n\n\n\n
The manufacturer wants to offer a completely open-source firmware again. However, since Linux on ARM architecture is not yet fully open-source, this will require some development effort. The exact details of the final price and official release on the market remain a secret, as the project will be financed through a crowdfunding campaign. However, the company has already opened a developer portal where programmers can actively participate in refining the software.<\/p>\n